Covenant Waterworks Logo

What to Do When a Pipe Bursts in Your Indiana Home

Published

Red and blue PEX water lines and white PVC drain pipes in a framed bathroom wall

A burst pipe can send a surprising amount of water into your home in very little time. Whether it happens in a crawlspace, behind a wall or under a sink, the steps you take in the first few minutes make a big difference to how much damage you end up with. This guide covers exactly what to do when a pipe bursts, why it happens in Indiana homes, and what a plumber will do to get things back to normal.

Step 1: Shut Off the Main Water Valve

Stopping the water is the most important thing you can do. Your main shut-off valve controls all the water coming into the house. In many East Central Indiana homes it is on a basement or crawlspace wall near where the water line enters, in a utility room, or near the water heater.

Turn the valve clockwise until it stops if it has a round handle. If it has a lever handle, turn it so the lever sits across the pipe. If you cannot find the valve or it will not turn, call a plumber right away.

If you only need to stop water to one fixture, such as a sink or toilet, the small shut-off valve under that fixture may be enough. When the leak is in a wall or ceiling, always use the main valve.

Step 2: Make the Area Safe

Water and electricity are a dangerous combination. If water is near outlets, light fixtures, appliances or your electrical panel, do not walk through it. Turn off power to the affected area at the panel only if you can reach the panel without stepping in water. Otherwise, call an electrician or your electric utility.

Keep children and pets away from wet areas, and watch for sagging ceilings, which can mean water is collecting above.

Step 3: Turn Off the Water Heater

With the water supply shut off, it is a good idea to turn off your water heater too. On an electric unit, switch off its breaker. On a gas unit, turn the control to the pilot or vacation setting following the instructions on the label.

Step 4: Drain the Remaining Water

Open cold water faucets around the house, starting with the lowest ones, to drain water still in the pipes. Flushing toilets once also helps empty the lines. This reduces the amount of water that can escape from the break.

Step 5: Find Where the Water Is Coming From

Look for the source of the leak so you can tell your plumber where it is. Check crawlspaces, unheated rooms, exterior walls and the areas under kitchen and bathroom sinks.

If the pipe burst because it froze, other pipes may still be frozen. Never use an open flame to thaw a pipe. Our guide to frozen pipes in Indiana homes explains the warning signs and when a plumber is needed.

If water is coming up through a floor drain rather than out of a pipe, you may be dealing with a different problem. See our guide to sewage backing up into your basement.

Step 6: Remove Water and Start Drying

Mop up standing water, move belongings to a dry area, and use fans and a dehumidifier to dry the space. Pull back wet rugs and remove items stored on the floor. Damp building materials can grow mold if they stay wet, and the U.S. Environmental Protection Agency's guide to mold and moisture in your home explains why drying wet areas quickly matters.

For large amounts of water, or if water has soaked into walls, ceilings or flooring, a water damage restoration professional can help dry the structure properly.

Step 7: Document the Damage

Before cleanup goes too far, take photos and video of the burst pipe, the water and any damaged property. Keep receipts for anything you buy to deal with the damage. Then contact your homeowners insurance company to ask about your coverage and the claims process. The Insurance Information Institute has more on freeze damage and homeowners insurance.

Why Pipes Burst in Indiana Homes

Understanding the cause helps prevent the next break.

  • Freezing. When water freezes, it expands and builds pressure inside the pipe. Indiana winters bring cold snaps that can freeze pipes in crawlspaces, garages and exterior walls. The National Weather Service's winter weather safety resources explain how to prepare before extreme cold arrives.
  • Corrosion. Older galvanized steel pipes, still found in many established homes, corrode from the inside and become weaker over time.
  • High water pressure. Pressure that is too high puts constant strain on pipes, joints and fixtures.
  • Physical damage. Shifting foundations, settling and accidental damage during home projects can crack a pipe.

What a Plumber Will Do

When you call Covenant Waterworks, we start by confirming the water is safely off and finding the exact location of the break. We repair or replace the damaged section of pipe, then check nearby lines for other weak spots, especially if freezing or corrosion caused the failure. Once the repair is complete, we restore water slowly and check for leaks. We also explain what caused the break and what you can do to reduce the risk of it happening again.

If the burst pipe is part of a larger problem with aging supply lines, our leak detection and pipe repair services cover hidden leaks, supply lines and main water lines.

Lower the Risk Next Winter

  • Know where your main shut-off valve is and make sure it turns freely.
  • Insulate pipes in crawlspaces, garages and exterior walls.
  • Disconnect garden hoses before freezing weather.
  • Keep your home heated, even when you are away.
  • On very cold nights, open cabinet doors under sinks on exterior walls so warm air can reach the pipes.

The American Red Cross offers more advice on preventing frozen pipes through the winter.

Get Help With a Burst Pipe

A burst pipe needs attention right away. Covenant Waterworks repairs burst and damaged pipes for homes in Muncie and across East Central Indiana. Call us, tell us what is happening, and we will tell you plainly when we can be there. Learn more about our emergency plumbing service.

Contact Covenant Waterworks

Phone: (765) 713-5746

Email: covenantwaterworks@gmail.com

Call NowGet a Quote